Oooo sanding is a good idea. Thanks. I suppose it will be some work but the cover will create a surface for the silicon lubricant instead of a hole so in the long run it will be for the better.
--- In [email protected], "melchan78" <[EMAIL PROTECTED]> wrote: > > Yeah, I got the same problem with the caps too. I thought of not > putting the caps on, but sometimes the other pieces get caught with > the corner pieces (because of the hole) resulting in not-so-smooth > turns. I ended up cutting small gaps in the edges of the caps so that > they line up nicely with the notches in the corner piece. I then put > the caps on and sand down the edges so that they are flat. It's a lot > of work but the cube turns very well now with the corner caps on. > > Older DIY cubes comes with the corner caps installed, so this is a > new feature... which brings me a lot of extra work! :( I ordered 4 > cubes so I have 3 more to work on... > > --- In [email protected], "Daniel Jih" > <[EMAIL PROTECTED]> wrote: > > > > Those replacement screws came today! Yay! > > > > Ok so while I'm assembling the cube, I need to tighten the screws > > depending on the tension. But how do I know how much to tighten? > > > > Also, the DIY kit corner cubies came with cover caps to cover the > > hollow side on the inside. Do any of you guys use them? Do they > help? > > Because I put them on, but they're not exactly perfect so they jut > out > > of the cubie a little bit and when I turn a side they catch on > something. > > > Yahoo! Groups Links <*> To visit your group on the web, go to: http://groups.yahoo.com/group/speedsolvingrubikscube/ <*> To unsubscribe from this group, send an email to: [EMAIL PROTECTED] <*> Your use of Yahoo! Groups is subject to: http://docs.yahoo.com/info/terms/
