Bonjour a tous, I'll write this in English so everyone can understand this. I'am trying to get OpenBSD (3.2) installed as router between the Internet and my home network. However I'am stuck at this point. The modem_run program (see messages log) is oke (as far as I can tell). Then ppp does not go thru the phases after authentication (PAP). Does any one have any idea on how I could take ppp trhu the next steps also?
Any help is much appriciated. Regards, Rene. My configuration: Software Configuration: OpenBSD 3.2 out of the box. PPPOA from the CVS Hardware: PC Kloon with Intel USB v1.0 Alcatel SpeedTouch 330 Dutch ADSL subscription (0/32) ================================= LOG EXCERPTS ============================ -------- begin snip messages log ----------- Jan 8 09:10:06 gw0 /bsd: ugen0: ALCATEL Speed Touch 330, rev 1.10/2.00, addr 2 Jan 8 09:10:06 gw0 /bsd: ugen1 at uhub0 port 2 Jan 8 09:10:06 gw0 /bsd: ugen1: - ADSL USB MODEM, rev 1.10/90.06, addr 3 Jan 8 09:10:06 gw0 savecore: no core dump Jan 8 09:29:39 gw0 modem_run[11475]: modem_run version started by rene uid 0 Jan 8 09:29:45 gw0 modem_run[11475]: Enabling SW buffering Jan 8 09:30:00 gw0 modem_run[11475]: ADSL synchronization has been obtained Jan 8 09:30:00 gw0 modem_run[11475]: ADSL line is up (512 kbit/s down | 128 kbit/s up) -------- end snip messages log ----------- -------- begin snip ppp.conf ----------- default: ident user-ppp VERSION (built COMPILATIONDATE) set log +phase +debug +dns +lcp +ccp #set log Phase Chat CBCP IPCP CCP tun command adsl: disable acfcomp protocomp vjcomp shortseq pred1 deflate disable ipv6cp disable dns set vj off set device !"/usr/local/sbin/pppoa2 -vpi 0 -vci 32 -v 1 -d /dev/ugen0" enable pap accept pap set speed sync enable lqr set lqrperiod 50 set redial 15 10000 set dial "" set ifaddr 0 0 set authname Rene@zonnet-family set authkey !geen_weg_terug! add! default HISADDR -------- end snip ppp.conf ----------- ------ snip part of ppp log ---- Jan 8 10:24:07 gw0 ppp[24147]: Debug: deflink: DescriptorRead: read 52/2048 from 0 Jan 8 10:24:07 gw0 ppp[24147]: Debug: proto_LayerPull: unknown -> 0xc025 Jan 8 10:24:07 gw0 ppp[24147]: Debug: link_PullPacket: Despatch proto 0xc025 Jan 8 10:24:08 gw0 ppp[24147]: Debug: deflink: DescriptorRead: read 9/2048 from 0 Jan 8 10:24:08 gw0 ppp[24147]: Debug: proto_LayerPull: unknown -> 0xc023 Jan 8 10:24:08 gw0 ppp[24147]: Debug: link_PullPacket: Despatch proto 0xc023 Jan 8 10:24:08 gw0 ppp[24147]: Phase: Pap Input: SUCCESS () Jan 8 10:24:58 gw0 ppp[24147]: Debug: proto_LayerPush: Using 0xc025 Jan 8 10:24:58 gw0 ppp[24147]: Debug: link_PushPacket: Transmit proto 0xc025 Jan 8 10:24:58 gw0 ppp[24147]: Debug: m_enqueue: len = 1 Jan 8 10:24:58 gw0 ppp[24147]: Debug: m_dequeue: queue len = 1 Jan 8 10:24:58 gw0 ppp[24147]: Debug: link_Dequeue: Dequeued from queue 1, containing 0 more packets Jan 8 10:24:58 gw0 ppp[24147]: Debug: deflink: DescriptorWrite: wrote 52(52) to 0 Jan 8 10:24:58 gw0 ppp[24147]: Debug: deflink: DescriptorRead: read 52/2048 from 0 Jan 8 10:24:58 gw0 ppp[24147]: Debug: proto_LayerPull: unknown -> 0xc025 Jan 8 10:24:58 gw0 ppp[24147]: Debug: link_PullPacket: Despatch proto 0xc025 Jan 8 10:25:48 gw0 ppp[24147]: Debug: proto_LayerPush: Using 0xc025 Jan 8 10:25:48 gw0 ppp[24147]: Debug: link_PushPacket: Transmit proto 0xc025 Jan 8 10:25:48 gw0 ppp[24147]: Debug: m_enqueue: len = 1 Jan 8 10:25:48 gw0 ppp[24147]: Debug: m_dequeue: queue len = 1 Jan 8 10:25:48 gw0 ppp[24147]: Debug: link_Dequeue: Dequeued from queue 1, containing 0 more packets Jan 8 10:25:48 gw0 ppp[24147]: Debug: deflink: DescriptorWrite: wrote 52(52) to 0 Jan 8 10:25:48 gw0 ppp[24147]: Debug: deflink: DescriptorRead: read 52/2048 from 0 Jan 8 10:25:48 gw0 ppp[24147]: Debug: proto_LayerPull: unknown -> 0xc025 Jan 8 10:25:48 gw0 ppp[24147]: Debug: link_PullPacket: Despatch proto 0xc025 Jan 8 10:25:58 gw0 ppp[24147]: Debug: deflink: DescriptorRead: read 8/2048 from 0 Jan 8 10:25:58 gw0 ppp[24147]: Debug: proto_LayerPull: unknown -> 0xc021 Jan 8 10:25:58 gw0 ppp[24147]: Debug: link_PullPacket: Despatch proto 0xc021 Jan 8 10:25:58 gw0 ppp[24147]: LCP: deflink: RecvTerminateReq(91) state = Opened Jan 8 10:25:58 gw0 ppp[24147]: LCP: deflink: LayerDown Jan 8 10:25:58 gw0 ppp[24147]: LCP: deflink: SendTerminateAck(91) state = Opened Jan 8 10:25:58 gw0 ppp[24147]: Debug: fsm_Output Jan 8 10:25:58 gw0 ppp[24147]: Debug: 06 5b 00 04 .[.. Jan 8 10:25:58 gw0 ppp[24147]: Debug: proto_LayerPush: Using 0xc021 Jan 8 10:25:58 gw0 ppp[24147]: Debug: link_PushPacket: Transmit proto 0xc021 Jan 8 10:25:58 gw0 ppp[24147]: Debug: m_enqueue: len = 1 Jan 8 10:25:58 gw0 ppp[24147]: LCP: deflink: State change Opened --> Stopping Jan 8 10:25:58 gw0 ppp[24147]: Debug: m_dequeue: queue len = 1 Jan 8 10:25:58 gw0 ppp[24147]: Debug: link_Dequeue: Dequeued from queue 1, containing 0 more packets Jan 8 10:25:58 gw0 ppp[24147]: Debug: deflink: DescriptorWrite: wrote 8(8) to 0 Jan 8 10:26:00 gw0 ppp[24147]: Debug: deflink: DescriptorRead: read 18/2048 from 0 Jan 8 10:26:00 gw0 ppp[24147]: Debug: proto_LayerPull: unknown -> 0xc021 Jan 8 10:26:00 gw0 ppp[24147]: Debug: link_PullPacket: Despatch proto 0xc021 Jan 8 10:26:00 gw0 ppp[24147]: LCP: deflink: RecvConfigReq(92) state = Stopping Jan 8 10:26:00 gw0 ppp[24147]: LCP: AUTHPROTO[4] 0xc023 (PAP) Jan 8 10:26:00 gw0 ppp[24147]: LCP: MAGICNUM[6] 0xea65fc15 Jan 8 10:26:01 gw0 ppp[24147]: LCP: deflink: LayerFinish Jan 8 10:26:01 gw0 ppp[24147]: LCP: deflink: State change Stopping --> Stopped Jan 8 10:26:01 gw0 ppp[24147]: LCP: deflink: State change Stopped --> Closed Jan 8 10:26:01 gw0 ppp[24147]: LCP: deflink: State change Closed --> Initial Jan 8 10:26:01 gw0 ppp[24147]: Phase: deflink: Disconnected! Jan 8 10:26:01 gw0 ppp[24147]: Phase: deflink: lcp -> logout Jan 8 10:26:01 gw0 ppp[24147]: Phase: deflink: logout -> hangup Jan 8 10:26:01 gw0 ppp[24147]: Phase: deflink: Disconnected! Jan 8 10:26:01 gw0 ppp[24147]: Debug: deflink: Close Jan 8 10:26:01 gw0 ppp[24147]: Phase: deflink: Connect time: 115 secs: 1121 octets in, 1183 octets out Jan 8 10:26:01 gw0 ppp[24147]: Phase: deflink: 57 packets in, 57 packets out Jan 8 10:26:01 gw0 ppp[24147]: Phase: total 20 bytes/sec, peak 687 bytes/sec on Wed Jan 8 10:24:08 2003 Jan 8 10:26:01 gw0 ppp[24147]: Phase: deflink: HUPing 1053 Jan 8 10:26:01 gw0 ppp[24147]: Phase: deflink: hangup -> closed Jan 8 10:26:01 gw0 ppp[24147]: Debug: route_IfDelete (11) Jan 8 10:26:01 gw0 ppp[24147]: Debug: Found ff02::%tun0/32 fe80::de5:9737%tun0 Jan 8 10:26:01 gw0 ppp[24147]: Debug: wrote 132: cmd = Delete, dst = ff02::%tun0/32, gateway = <none> Jan 8 10:26:01 gw0 ppp[24147]: Phase: bundle: Dead Jan 8 10:26:01 gw0 ppp[24147]: Debug: route_UpdateMTU (11) Jan 8 10:26:01 gw0 ppp[24147]: Debug: DoLoop done. Jan 8 10:26:01 gw0 ppp[24147]: Phase: PPP Terminated (normal). Jan 8 10:26:01 gw0 ppp[24147]: Debug: route_IfDelete (11) Jan 8 10:26:01 gw0 ppp[24147]: Debug: Radius: radius_Destroy -------- snip end ppp log ------ Liste de diffusion modem ALCATEL SpeedTouch USB Pour se d�sinscrire : mailto:[EMAIL PROTECTED]?subject=unsubscribe
