Hi, I had the same problem.
Check that you ONLY use ppp (aka. user-ppp) and not pppd. pppd does not support the 'pty' setting, and thus can not be used. What I did was go on to the CVS and download the lastest from there. Do make and configure, which run fine. And after that install these two files (modem_run and pppoa2). I was left stuck then cause my ppp session does pass the Ppp, i.e (Authentication Done, LCP Finished) according to PPP. In the log files the last I see is, PAP input: SUCCESS() and after that nothing anymore, and a disconnect after a while. I' am telling you this, because I do not know if this behaivor is because of the CVS version, my provider, OpenBSD 3.2, etc.. I even disable the GRE device since, it seems sometimes to block proper operation of ppp. GOOD LUCK, let me know what you're findings are? Regards, Rene. At 05:44 PM 1/14/2003 +0000, you wrote: >Hi there, > >I have been using the b version speedtouch drivers with OpenBSD 3.1 for a >while with great success. I recently rebuilt a number of machines to vanilla >generic 3.2. I have downloaded the 19/11/02 CVS drivers and installed as >normal, when I issue - > >/usr/local/sbin/modem_run -f /usr/local/libdata/mgmt/mgmt.o -d /dev/ugen0 -v >2 -m > >It justs sits there doing nothing - modem_run is listed in top, with a WAIT >state of 'ugenwb' - it is driving me nuts due to none of the hardware has >changed > >Any ideas? - thanks in advance - Tim > > > > >** For great Emap magazine subscription & gift offers visit >http://www.emapmagazines.co.uk ** > >-------------------------------------------------------------------------------- >The information in this email is intended only for the addressee(s) named above. >Access to this email by anyone else is unauthorised. >If you are not the intended recipient of this message any disclosure, copying, >distribution or any action taken in reliance on it is prohibited and may be unlawful. > >Emap plc and or its subsidiaries do not warrant that any attachments are free from >viruses or other defects and accept no liability for any losses resulting from >infected email transmissions. > >Please note that any views expressed in this email may be those of the originator >and do not necessarily reflect those of this organisation. >-------------------------------------------------------------------------------- > > > >Liste de diffusion modem ALCATEL SpeedTouch USB >Pour se d�sinscrire : mailto:[EMAIL PROTECTED]?subject=unsubscribe > > Liste de diffusion modem ALCATEL SpeedTouch USB Pour se d�sinscrire : mailto:[EMAIL PROTECTED]?subject=unsubscribe
