I have notebook with default installation of Fedora 4 and braodband via USB Thomson Speedtouch 330 modem. I did everything as I was told by site www.linux-usb.org/SpeedTouch/fedora/. I downloaded firmware, put this line into /etc/ppp/chap-secrets
'username isp' * 'password' and created file /etc/sysconfig/network-scripts/ifcfg-ppp0 PEERDNS=yes TYPE=xDSL DEVICE=ppp0 BOOTPROTO=dialup PIDFILE=/var/run/pppoa-adsl.pid LCP_FAILURE=86400 LCP_INTERVAL=1 CONNECT_POLL=6 CONNECT_TIMEOUT=604800 SYNCHRONOUS=no DEFROUTE=yes USER='username isp' VPI=0 VCI=38 LINUX_PLUGIN=pppoatm.so DEMAND=yes I JUST REBOOTED AND EVERYTHING WORKED JUST FINE! But now I have two more computers at home and they need internet as well. I bought cheap Pentium II 350 for router, installed the same FC4 from the same CDs. Did all the same steps as I did with my notebook. But I have not the same results. On boot time during ppp0 initialization I get message does not seem to be present, delaying initialization. [FAILED] And there is all relevant output in /var/log/messages I have Oct 12 16:43:33 octopus kernel: hub 1-0:1.0: USB hub found Oct 12 16:43:33 octopus kernel: hub 1-0:1.0: 2 ports detected Oct 12 16:43:33 octopus kernel: usb 1-1: new full speed USB device using uhci_hcd and address 2 Oct 12 16:43:34 octopus kernel: usb 1-1: reset full speed USB device using uhci_hcd and address 2 Oct 12 16:43:34 octopus kernel: usbcore: registered new driver speedtch Oct 12 16:43:34 octopus kernel: speedtch 1-1:1.0: found stage 1 firmware speedtch-1.bin Oct 12 16:43:34 octopus kernel: speedtch 1-1:1.0: found stage 2 firmware speedtch-2.bin Oct 12 16:43:34 octopus kernel: ATM dev 0: ADSL line is synchronising Oct 12 16:43:35 octopus kernel: ATM dev 0: ADSL line is up (2272 kb/s down | 288 kb/s up) While on my notebook, which works just fine, I get much more output on /var/log/messages: Oct 12 10:49:09 pasaka pppd[2006]: Plugin pppoatm.so loaded. Oct 12 10:49:09 pasaka pppd[2006]: PPPoATM plugin_init Oct 12 10:49:09 pasaka pppd[2006]: PPPoATM setdevname_pppoatm - SUCCESS:0.38 Oct 12 10:49:09 pasaka pppd[2006]: pppd 2.4.2 started by root, uid 0 Oct 12 10:49:09 pasaka pppd[2006]: Using interface ppp0 Oct 12 10:49:09 pasaka pppd[2006]: local IP address 10.112.112.112 Oct 12 10:49:09 pasaka pppd[2006]: remote IP address 10.112.112.113 Oct 12 10:49:10 pasaka pppd[2006]: Starting link Oct 12 10:49:10 pasaka pppd[2006]: Connect: ppp0 <--> 0.38 Oct 12 10:49:10 pasaka pppd[2006]: Couldn't increase MTU to 1500. Using 1492 Oct 12 10:49:10 pasaka pppd[2006]: Couldn't increase MRU to 1500. Using 1492 Oct 12 10:49:10 pasaka kernel: usbcore: registered new driver usbfs Oct 12 10:49:10 pasaka kernel: usbcore: registered new driver hub Oct 12 10:49:13 pasaka pppd[2006]: Couldn't increase MTU to 1500. Using 1492 Oct 12 10:49:13 pasaka pppd[2006]: Couldn't increase MTU to 1500. Using 1492 Oct 12 10:49:14 pasaka pppd[2006]: Couldn't increase MRU to 1500. Using 1492 Oct 12 10:49:14 pasaka pppd[2006]: Couldn't increase MTU to 1600. Using 1492 Oct 12 10:49:14 pasaka pppd[2006]: Couldn't increase MRU to 1500. Using 1492 Oct 12 10:49:14 pasaka pppd[2006]: CHAP authentication succeeded Oct 12 10:49:14 pasaka kernel: usbcore: registered new driver hiddev Oct 12 10:49:14 pasaka pppd[2006]: Local IP address changed to 84.43.100.94 Oct 12 10:49:14 pasaka kernel: usbcore: registered new driver usbhid Oct 12 10:49:15 pasaka pppd[2006]: Remote IP address changed to 212.67.121.45 Oct 12 10:49:18 pasaka kernel: hub 4-0:1.0: USB hub found Oct 12 10:49:18 pasaka kernel: hub 4-0:1.0: 2 ports detected Oct 12 10:49:18 pasaka kernel: usb 2-1: new low speed USB device using uhci_hcd and address 2 Oct 12 10:49:18 pasaka kernel: usb 2-2: reset full speed USB device using uhci_hcd and address 3 Oct 12 10:49:18 pasaka kernel: usbcore: registered new driver speedtch Oct 12 10:49:18 pasaka kernel: speedtch 2-2:1.0: found stage 1 firmware speedtch-1.bin Oct 12 10:49:18 pasaka kernel: speedtch 2-2:1.0: found stage 2 firmware speedtch-2.bin Oct 12 10:49:18 pasaka kernel: ATM dev 0: ADSL line is synchronising Oct 12 10:49:20 pasaka kernel: ATM dev 0: ADSL line is up (2272 kb/s down | 288 kb/s up) Can anyone give me a clue what is wrong? -- Dovydas Sankauskas Liste de diffusion modem ALCATEL SpeedTouch USB Pour se d�sinscrire : mailto:[EMAIL PROTECTED]
