2010/9/2 <[email protected]>: > This patch changes the way SPI transfers are setup. The previous > method uses the pl022_config_chip data for configuration of > loopback mode, edge count, clock polarity, number of data bits, > and bit transfer order. This change configures these parameters > based on spi->mode passed via master->setup and will allow the > drivers use SPI to configure the interface.
Hi Kevin, sorry for the late answer ... too busy. This definiately looks like the right way to do this to my now a bit non-uptodate eye, but I'm running it by my current SPI ace Lukasz @Tieto, so he can object if there is some problem with it, else: Acked-by: Linus Walleij <[email protected]> Yours, Linus Walleij ------------------------------------------------------------------------------ This SF.net Dev2Dev email is sponsored by: Show off your parallel programming skills. Enter the Intel(R) Threading Challenge 2010. http://p.sf.net/sfu/intel-thread-sfd _______________________________________________ spi-devel-general mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/spi-devel-general
