You know, in retrospect, I shouldn't have put most of those SPI device setup params into the board setup data.
There's one which MUST be there: polarity of the chip select line. The rest seem like they could (and arguably should) all be handled by driver-specific params. (Possible exception: clock rate, which sometimes matters even when chips are not selected). At any rate, adding MORE driver-specific params (like bits-per-word) to board setup data seems like the wrong direction to go... ------------------------------------------------------------------------------ This SF.net Dev2Dev email is sponsored by: Show off your parallel programming skills. Enter the Intel(R) Threading Challenge 2010. http://p.sf.net/sfu/intel-thread-sfd _______________________________________________ spi-devel-general mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/spi-devel-general
