On Tue, Jun 21, 2011 at 10:20 PM, Stefan Schmidt <[email protected]> wrote: > Hello. > > On Tue, 2011-06-21 at 22:08, Eric Miao wrote: >> On Tue, Jun 21, 2011 at 10:03 PM, Stefan Schmidt >> <[email protected]> wrote: >> > On Thu, 2011-06-16 at 17:44, Eric Miao wrote: >> > > On Thu, Jun 16, 2011 at 5:19 PM, Stefan Schmidt >> > > <[email protected]> wrote: >> > > > >> > > > Its either 8bit or 16bit for a message. The mentioned problem happens >> > > > on a 8 bit message. It does nothing else then writing to a defined >> > > > register address to trigger the hardware sending the data in the FIFO. >> > > >> > > This might get too much overhead. I didn't check the source code, but >> > > my guess is it's waiting for interrupt for each message, and once the >> > > interrupt of message being flushed out happens, it starts the next one >> > > waiting for the FIFO empty interrupt coming. Did you try stuff more >> > > bytes into a single message? >> > >> > Took me some time to implement and test al kind of different >> > scenarios. As you suggested I tried to stuff more bytes into a message >> > as well as testing all kind of combination with tx and rx thresholds, >> > timout, PIO and DMA, cs_change , etc. No change. >> > >> > I then bit the bullet and changed the board to use the spi_gpio driver >> > instead of pxa2xx. After some struggling (make sure you setup pin >> > config correctly :)) I got it working but with the same result. >> > >> > My last test block was around using spi_async() instead of spi_sync >> > and as well I was not able to reach my timing criteria. :( >> > >> > To me it seems right now as if it is just not possible to reach >> > something in the 100 usec range with the SPI framework. Obviuously I >> > would be loved to be proven wrong. :) >> > >> > As I'm running way out of time for this part of my project I'm back to >> > the driver now trying to find a solution that avoids the tight timing >> > criteria. >> >> I think for a time budget like this, you may want to try a dedicated >> polling driver avoid all the interrupt/wait stuff, that's going to maximize >> the throughput. If that's even not possible, it might be HW limitations. > > You mean like configuring the pins as plain GPIO and have some small > bitbang functions on my own without the SPI framework? Just trying to > understand in what direction you are pointing me. :)
I mean just to have a small driver, configure the SPI controller with hardcoded values, and try writing to the SSDR all by yourself, and polling the SSSR status bits. Not something simulating SPI w/ GPIO, that will be slow. > > I might have to try this if it turns out that wrokign around it in the > driver does not work (lets hope at least _something_ works). :) > > regards > Stefan Schmidt > ------------------------------------------------------------------------------ EditLive Enterprise is the world's most technically advanced content authoring tool. Experience the power of Track Changes, Inline Image Editing and ensure content is compliant with Accessibility Checking. http://p.sf.net/sfu/ephox-dev2dev _______________________________________________ spi-devel-general mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/spi-devel-general
