Been awhile since I spoke up on the list, so I suppose it is about time. (might of been a refreshing silence for some of you. :) )
I have reinstalled the window in my drivers door and now need to install the rubber seal that is placed on the windshields upright. This is the seal that has a 1 1/2" flat section with a round tube like section running on one edge, not the furflex/rubber type seal that runs the whole way around the door. I have a new seal but am unsure of how to place it, or attach it. I presume by looking at it that it is cut to fit? and the one should be enough for both sides. Can someone tell me 1) from what point to what point does this run. 2) What orientation does this lay in? 3) How do you attach it 4) should I wait until after the furflex is installed to place this? I appreciate the help. Patrick Bowen * Confidentiality Notice * The information in this e-mail/facsimile transmission is intended by intellinetics, Inc. for use only by the individual or entity to which it is addressed. This message may contain information that is privileged or confidential. If you are not the intended recipient, you are hereby notified that any dissemination, distribution or copy of this e-mail/facsimile is strictly prohibited. If you have received this transmission in error, please delete it from your system without copying or forwarding it, and notify the sender of the error by reply e-mail or by calling 614-921-8170. Thank You * intellinetics, Inc. * 2190 Dividend Drive * Columbus, OH 43228 * Phone: (614) 921-8170 * www.intellinetics.com * Fax: (614) 850-2789 /// [EMAIL PROTECTED] mailing list /// Send admin requests to [EMAIL PROTECTED] /// or try http://www.team.net/cgi-bin/majorcool /// Archives at http://www.team.net/archive /// Send list postings to [EMAIL PROTECTED] /// Edit your replies! If they include this trailer, they will NOT be sent.
