Geoff,

All the internal stuff must come out. There are four (4) bolts holding the glass guide 
rails in place (two each). The regulator (channel?) that runs the BOTTOM length of the 
glass must be disconnected. This is the real pain, if you've not done it before. There 
are two (2) clips which 'mount' the glass to it, but they are on the 'other' side... 
that is, mounted where you cannot see them. Reach behind, and you will feel them with 
your finger tips. Pretend for a second that this 'clip' is a large washer... coming 
from the edge of the washer, is a curved piece of metal about 1/4" wide, which goes to 
the center of the 'hole' in the washer, then stops. This is what 'clips' the thing in 
place on the glass. You must slide, or 'push' this thing BACK, in order to release it 
from the mounting pins (two of them). Once you get them off, and can visibly see them, 
it is very easy to then understand them. Once off, remove the regulator and other 
associated small stuff, then remove the glass!
 through the top openning (i.e. where it is rolled up/down through).

Best of luck,

Gary Durham

P.S. keep track of those little rubber washers for re-assembly.




________________________________________________________________
GET INTERNET ACCESS FROM JUNO!
Juno offers FREE or PREMIUM Internet access for less!
Join Juno today!  For your FREE software, visit:

///  [EMAIL PROTECTED] mailing list
///  Send admin requests to [EMAIL PROTECTED]
///  or try  http://www.team.net/cgi-bin/majorcool
///  Archives at http://www.team.net/archive
///  Send list postings to [EMAIL PROTECTED]
///  Edit your replies!  If they include this trailer, they will NOT be sent.

Reply via email to