Maurice, I have tried TR6 manifolds upside down, but even with maximum hood adjustment i was always just never able to fully close the bonnet without resting the bonnet on the front CD175 carb. As I recall, if you turn the manifold upside down you would also have to design a new system in which you secure the manifold properly to the block, as now the flanges are out of place. Even though the TR6 carbs were now angled down somewhat they still did not fit. If you are able to drop the motor a half inch or so it may be possible; though you may be sitting the sump on the steering rack.
Also as I recall there is only one GT6 cylinder head/ TR6 manifold combination that would work either side up and still line up the ports properly. That combination would be a later gt6 cylinder head (Mk2-MK3) with a later TR6 manifold that has the 7/8" spacing (not sure of years). The earlier TR6 manifold with 5/8" spacing between the ports will run and will bolt on but it will not run well as the ports are mismatched as evidenced through head gasket impressioning. I have a friend who has said he had at one time created aluminum plates which sandwiched inbetween the CD175 carbs and the stock 1.5" manifold. Apparently he says one of the top carb holes bolted right through to the manifold and the rest were bolted to the aluminum spacer , and the aluminum spacer was bolted through the rest of the manifold holes. He said there was a performance increase, but I do not understand how that would be if still using the stock manifold. I have seen a few GT6's that have had an extra hood bubble put in the bonnet in order to clear the front CD175 carb, this always works but it detracts from the look of the car. I will be looking at this option soon as I would like to feed my stroked engine with the stock TR6 carbs (as opposed to the CD150s I have been using). I have heard somewhere that the CD150s are sufficient for 2.5L, but I would rather run 175's regardless. I cannot remember if I had the air cleaners on the TR6 carbs when I was trying different combinations; if someone has tried this before can they please respond with their experiences? Hope that helps, Steve '70 GT6's > > Does anyone remember the model year intake manifold (perhaps TR250) > > that could installed upside down to allow hood clearance with the Gt6? > > > > This is an old well known tip but the details escape me. > > > > -Maurice /// [EMAIL PROTECTED] mailing list /// Send admin requests to [EMAIL PROTECTED] /// or try http://www.team.net/cgi-bin/majorcool /// Archives at http://www.team.net/archive /// Send list postings to [EMAIL PROTECTED] /// Edit your replies! If they include this trailer, they will NOT be sent.
