Here's two questions for the price of one. Totally different topics, but I've been busy putting the finishing touches on my project.
1. No joy from the horn. Horn brush checked out, horn push does in fact have continuity all the way to the relay. Checked it with my volt meter. Relay is getting steady 12v from fuse #3, no trouble there. Horns are NOS, properly grounded, and give a very nice toot when voltage is directly applied, bypassing the relay. Is my new horn relay DOA? I can't think of any other possibility. The wires are correctly routed to the right terminals. Any way to check the relay itself? It doesn't click. 2. Anyone successfully fit the intermediate stainless pipe (with the little resonator) from Bell to their 4-2-1 Bell headers? I just spent a frustrating hour under the car, trying to finagle the thing into position, but the bend on the header side is backwards. If I rotate the pipe to get the correct insertion angle, the other end of it is poking down at the front of my left rear tire. Not good. I see no way to fit this thing without assistance from the muffler shop who will have to cut and or bend it into position. I'm opting to return it for a refund since I'm having to involve the pros, anyway. Their stainless pipe is probably a lot cheaper. I was just wondering if others have experienced the same trouble. Take care, Jeff in San Diego 1968 Spitfire Mk3 aka "Mrs. Jones" ...Dangerously close to completion. Visit the Totally Triumph Network "Friendly and focused discussion of all things Triumph!" www.TotallyTriumph.net /// [EMAIL PROTECTED] mailing list /// Send admin requests to [EMAIL PROTECTED] /// or try http://www.team.net/cgi-bin/majorcool /// Archives at http://www.team.net/archive /// Send list postings to [EMAIL PROTECTED] /// Edit your replies! If they include this trailer, they will NOT be sent.
