Anyone ever had their mechanical tach run too high at higher RPM's?  It's
pretty close to correct on the low range of the gauge, but at 3400 RPM, my
needle says 4000!!  I knew I had a problem and confirmed it with an electronic
tach.  The cable is new, and on top of that I used liquid graphite the inner
cable it before installation, so I know that isn't the problem.  The needle
also appears nice and steady while in use.

Any suggestions?  I was thinking about winding the needle one more revolution
so that more resistance is encountered when the needle is climbing.

TIA

Jeff

///  [EMAIL PROTECTED] mailing list
///  Send admin requests to [EMAIL PROTECTED]
///  or try  http://www.team.net/cgi-bin/majorcool
///  Archives at http://www.team.net/archive
///  Send list postings to [EMAIL PROTECTED]
///  Edit your replies!  If they include this trailer, they will NOT be sent.

Reply via email to