A while back there was a thread about adding a pcv valve to a Weber setup by tapping a port into the Canon manifold below the carb itself. I've looked all mornings for the email in the archives that had the photos and the parts list, with no luck. I'm about to swap my stock header and cat converter for a HPC coated 4-2-1 stainless steel header, and now is the time to make the connection. Does anyone have the info on the part number for the pcv valve that will work with a 1980 Spit with a Weber down draft? Is it still a good idea? My valve cover vent now runs to a carbon canister after a "T" to the bottom of the air cleaner.
Also, I purchased a couple of those bonnet locks from VB a while ago, but there were no instructions as to the preferred location for the locks. Any ideas? Any experiences? Dan Parrott Savannah, Ga 1980 Spit "PJ" /// [EMAIL PROTECTED] mailing list /// Send admin requests to [EMAIL PROTECTED] /// or try http://www.team.net/cgi-bin/majorcool /// Archives at http://www.team.net/archive /// Send list postings to [EMAIL PROTECTED] /// Edit your replies! If they include this trailer, they will NOT be sent.
