If you want to get the top on at short notice, you can get away without the brackets to the B-pillars (if you are missing those right now). In that case, all you need is a pair of 1/2"-head bolts (can't remember thread size, but it's whatever UNC thread normally comes with a 1/2" head) to hold the hard-top to the windscreen, and another pair to hold the hard-top to the rear deck. The ones to the windscreen need to be roughly the right length - too short and they'll not thread in of course, and too long and they will bottom out on the outer skin of the hard-top before they are tight against the windscreen frame. If there is somewhere between 1/2" and 1" left when the end of the bolt starts to screw into the nut you'll be fine.
If you have got the side brackets, they just need a 7/16" head UNC bolt each side - one of the ones that usually holds the soft-top frame on will do. If you are like most Triumph owners, I'd be surprised if some appropriate bolts aren't lying around somewhere in your garage! Richard & Daffy This email and any attached files are confidential and copyright protected. If you are not the addressee, any dissemination of this communication is strictly prohibited. Unless otherwise expressly agreed in writing, nothing stated in this communication shall be legally binding. /// [EMAIL PROTECTED] mailing list /// Send admin requests to [EMAIL PROTECTED] /// or try http://www.team.net/cgi-bin/majorcool /// Archives at http://www.team.net/archive /// Send list postings to [EMAIL PROTECTED] /// Edit your replies! If they include this trailer, they will NOT be sent.