To go along with your findings on the upper perch. I didn't run anything other than the upper perch, no rubber, not a washer...just the spring directly contacted to the perches. I don't know what that would do as far as ride quality to run without the rubbers as ride quality wasn't my primary objective.
Aaron -----Original Message----- From: Larry Vaughan [mailto:[EMAIL PROTECTED] Sent: 23 December 2003 21:38 To: Aaron Johnson Cc: [EMAIL PROTECTED] Subject: Re: Spax dampers Aaron suggested; >Check and make sure that the lower seat is full nested. There always >seemed to be an issue with that little plate seating correctly. The >end coil could play a roll in the equation as well. Is the spring >fully seating on the plate? I had a set of springs that the i.d. of >the spring was slightly small and didn't fit the lower perch correctly. >Do you have a picture of them with the springs on? After some adjustments, I got the springs lined up and got pics also. http://www.ljvaughan.homestead.com/spaxdampers.html Larry *** http://www.team.net/the-local *** *** unsubscribe/change address requests to [EMAIL PROTECTED] or try *** http://www.team.net/cgi-bin/majorcool *** http://www.team.net/mailman/listinfo *** Archives at http://www.team.net/archive *** Edit your replies!
