Todd,

FWIW, I used all parts from Spitbits when I rebuilt my 1500 engine 3 years
ago.  There have been no problems.  I have not torn it down to check for
wear since.  Personally, I'd run anything Nigel sells with little worry.

BillG




-----Original Message-----
From: [EMAIL PROTECTED]
[mailto:[EMAIL PROTECTED] Behalf Of Todd france
Sent: Friday, March 26, 2004 5:08 PM
To: [EMAIL PROTECTED]
Subject: Re: spitfire bottom end rebuild


hi again yeah I have a set of mis sized county bearings from awhile back, is
county the same as king? and would everyone agree these are the best
substitute for the  "good vandervells" ??

 thanks, Todd... also where can I get vandervel thrustwashers?

  it's safe to say the thrust washers on spits bits are not worth while
right?

***     http://www.team.net/the-local    ***

Your messages not reaching the list?
Check out http://www.team.net/posting.html

***  unsubscribe/change address requests to [EMAIL PROTECTED]  or try
***  http://www.team.net/cgi-bin/majorcool
***  http://www.team.net/mailman/listinfo
***  Archives at http://www.team.net/archive
***  Edit your replies!

Reply via email to