Stud welders are the way to go. There are a few sizes of studs. The smaller 
ones are for sheet metal. The larger ones are for pulling out B post areas and 
heavier metal. Sometimes the studs can be broken off with pliers but sometimes 
the plier removal method leaves a hole in the sheetmetal. I prefer to grind 
them off to minimize the need to weld a hole closed. A huge improvement over 
the drill a hole and insert the slide hammer method because you don't wind up 
with a pannel with holes all over it.
Rob


-----Original Message-----
From: [EMAIL PROTECTED]
[mailto:[EMAIL PROTECTED] Behalf Of [EMAIL PROTECTED]
Sent: Tuesday, November 01, 2005 4:10 PM
To: Dan Canaan
Cc: [email protected]; [EMAIL PROTECTED]
Subject: Re: Body work suggestions?


Hello,

If anybody has any experience with those cheaper (e.g. Harbor Freight) stud 
welders,
I'd like to hear about it. 

Your messages not reaching the list?
Check out http://www.team.net/posting.html

===  This list supported in part by The Vintage Triumph Register
===     http://www.vtr.org

===  unsubscribe/change address requests to [EMAIL PROTECTED]  or try
===  http://www.team.net/cgi-bin/majorcool
===  Other lists available at
===      http://www.team.net/mailman/listinfo
===  Archives at http://www.team.net/archive
===  http://www.team.net/the-local
===  Edit your replies!

Reply via email to