I had some cracks in my floor, caused by the seat rail flexing I guess. The cracks spread from the left front driver seat rail bolt hole. I put the thinnest wire available in my mig welder and had a go at welding up the cracks. After welding and grinding and patching holes over a period of 4 days, I began to question when I should stop. Is when no light shows through good enough? Do the beads need ground down smooth to prevent rust? Will a coat of epoxy, like JB weld, strengthen the areas that got ground down thinner than the original sheet metal dimensions?

http://ljvaughan.homestead.com/sheetweld.html

Larry

Your messages not reaching the list?
Check out http://www.team.net/posting.html

===  This list supported in part by The Vintage Triumph Register
===     http://www.vtr.org

===  unsubscribe/change address requests to [EMAIL PROTECTED]  or try
===  http://www.team.net/cgi-bin/majorcool
===  Other lists available at
===      http://www.team.net/mailman/listinfo
===  Archives at http://www.team.net/archive
===  http://www.team.net/the-local
===  Edit your replies!

Reply via email to