Eduard Tieseler wrote:

Thanks for the response so far.
I do not have a presure regulator installed.  I'll
inspect the carbuerator for any "gummed up" jets. What about using a can of the fuel system cleaner next
time I fill up?  Or will that eat through any of the
rubber fuel lines?  I was thinking about it being an
electrical problem, but wouldn't that give me troubles
at all speeds?  If I cruise at about 45 MPH I do not
have an issue, If I increase my speed to say 55 or
60MPH it starts to act up in a few minutes.  what I
ended up doing was speeding up, then pushing in the
clutch for about 10 or 20 seconds then speeding up
again.  So on and so forth for about 5 miles.  That
wasn't fun!


My question is this: what I don't recall mentioned was if this is a new installation of cam, carburetor and/or engine? If not, was the engine running properly beforehand, and is this a new problem that developed suddenly? If a new installation, what is the carburetor model and jetting, if you know?

Cheers.

--
Michael D. Porter
Roswell, NM

Never let anyone drive you crazy when you know it's within walking distance....

Your messages not reaching the list?
Check out http://www.team.net/posting.html

===  This list supported in part by The Vintage Triumph Register
===     http://www.vtr.org

===  Help keep Team.Net on the air
===     http://www.team.net/donate.html

===  unsubscribe/change address requests to [EMAIL PROTECTED]  or try
===  http://www.team.net/cgi-bin/majorcool
===  Other lists available at
===      http://www.team.net/mailman/listinfo
===  Archives at http://www.team.net/archive
===  http://www.team.net/the-local
===  Edit your replies!

Reply via email to