I have just about the same setup on my '72. Possibly one or both carb butterfly valves are not properly installed on the throttle shafts, and they do not close fully?
Are the correct springs in the dampers? Also make sure that the air filters, etc. do not block the vent holes on the outer flange of the carbs (where the air filters bolt up). If you install the filters upside-down these vents will be blocked. Do you have one of those flat round PCV valves on the manifild? Is it properly hooked up? Good Luck, Doug Braun '72 Spit --- Jeffery Maurer <[EMAIL PROTECTED]> wrote: > I am installing a set of HS2 carbs, AUD's 285's > from a 1969 Spit to a 1972 > stock engine Spit. Your messages not reaching the list? Check out http://www.team.net/posting.html === This list supported in part by The Vintage Triumph Register === http://www.vtr.org === Help keep Team.Net on the air === http://www.team.net/donate.html === unsubscribe/change address requests to [EMAIL PROTECTED] or try === http://www.team.net/cgi-bin/majorcool === Other lists available at === http://www.team.net/mailman/listinfo === Archives at http://www.team.net/archive === http://www.team.net/the-local === Edit your replies!
