Two tips -- use your hand to press the brake pedal, and use clear vinyl tubing attached to the bleeder screws. Make the tubing long enough to raise the end well above the bleeder screw. It's best to try to have the tubing slope continuously up from the bleeder screw. This will keep all air from the bleeders, even better than dropping a hose in a bottle of brake fluif.
Crack one rear (or front) bleeder screw and press the pedal firmly to move the shuttle from wherever it is to where you don't want it (off-center.) Close that bleeder and open one in the other end of the vehicle, and press gently until you feel the "give" and the brake warning lamp goes out. Close the bleeder screw and have a Spitfire (ale or drive, your choice.) Donald. -------------- Original message ---------------------- From: "Jim Muller" <[EMAIL PROTECTED]> > Sorry if this is a duplicate post. > > Late this afternoon, the Lord willin' and the creek don't rise, I'll > fire up the Spitfire today after its long nap. Having installed and > bled new brake lines, I won't be surprised to find that the PDWA is > uncentered. I can imagine several ways to fix it, but I'm open to > suggestions. Advice is welcome. > > Thanks. > > > -- > Jim Muller > [EMAIL PROTECTED] > '80 Spitfire, '70 GT6+ Your messages not reaching the list? Check out http://www.team.net/posting.html === This list supported in part by The Vintage Triumph Register === http://www.vtr.org === Help keep Team.Net on the air === http://www.team.net/donate.html === unsubscribe/change address requests to [EMAIL PROTECTED] or try === http://www.team.net/cgi-bin/majorcool === Other lists available at === http://www.team.net/mailman/listinfo === Archives at http://www.team.net/archive === http://www.team.net/the-local === Edit your replies!
