I got my car back tonight with new automatic choke installed. It was set to the Basic setting (whatever that is). It was 40 degrees out when I started it. I did not let it warm up much, maybe a minute or two.
When driving it, same old problems. Dies when I come to a stop and acts like it is not getting enough air or gas. The Temp guage never moved and I am not sure if it is disconnected or just never warmed up. I drove it 5 miles home for about 10 minutes and the guage did not move and it acted like it used to when it was cold. The Weber carb is set at 850rpm for idle. When first cranked and cold, the choke has it the idle around 2K. I am going to mess with it more tomorrow and first check the temp guage and then let it try to warm up on choke like it is supposed to. Any suggestions? I am going to get all of the old gas out and put 93 octane in as well (has 87 now). Surely the car would have warmed up in 15 or minutes? Thanks shane ____________________________________________________________________________________ Cheap talk? Check out Yahoo! Messenger's low PC-to-Phone call rates. http://voice.yahoo.com Your messages not reaching the list? Check out http://www.team.net/posting.html === This list supported in part by The Vintage Triumph Register === http://www.vtr.org === Help keep Team.Net on the air === http://www.team.net/donate.html === unsubscribe/change address requests to [EMAIL PROTECTED] or try === http://www.team.net/cgi-bin/majorcool === Other lists available at === http://www.team.net/mailman/listinfo === Archives at http://www.team.net/archive === http://www.team.net/the-local === Edit your replies!
