Bob, I sent a pic off list. I used bolts that thread into the block, with washers to take up any slack for the two top stand brackets, and long bolts with coarse threads, and again washers to take up the slack, secured to the engine plate. You can't remove the crank with the rear plate still installed. So depending on what you intend, you might want to take off the rear plate, and secure the stand brackets into the holes securing the plate.
Hope that helps. Nick Moseley -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of [EMAIL PROTECTED] Sent: Tuesday, September 02, 2008 10:05 AM To: [email protected] Subject: [Spits] engine stand Does anyone have some photos of a block on an engine stand? The small diameter threads on the back of the block scare me. Anyone have similar concerns. I guess a picture is worth a thousand words.... thanks in advance, Bob _______________________________________________ Support Team.Net http://www.team.net/donate.html [email protected] http://autox.team.net/mailman/listinfo/spitfires http://www.team.net/archive
