The Mk1 has one timing mark on the pulley. It indicates TDC. You set the timing by adjusting the vernier adjustor knob on the distributor to change the timing in 1 degree increments.
Start by turning the crankshaft so that Cylinder 1 is at TDC and rotate the distributor until the points are just beginning to open. Tighten the clamp and adjust the vernier 13 clicks clockwise to achieve the 13 degrees BTDC that is recommended. Note: Make sure that you have sufficient adjustability range of the vernier before you start. Joe -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Steve Beswick Sent: Tuesday, November 11, 2008 2:02 PM To: [email protected] Subject: [Spits] mk1 timing How do I check / adjust the ignition timing on a mk1 Spitfire? Where are the timing marks? [email protected] http://autox.team.net/mailman/listinfo/spitfires http://www.team.net/archive _______________________________________________ Support Team.Net http://www.team.net/donate.html [email protected] http://autox.team.net/mailman/listinfo/spitfires http://www.team.net/archive
