Well it looks like the 1500 engine I picked up is now a 1500 boat anchor. As I was pulling the camshaft out of the block, or attempting to, I noticed that the reason I couldnt withdraw it from the block was because that the 2nd bearing journal on the cam was badly scored, and that was because the cast bridge supporting the journal was cracked all the way through It now looks like the good deal that I thought I had wasnt so good after all. I seriously doubt that the bridge could be welded up and the bearing bore reground, and even if it could, it would probably just crack again anyway. So I am searching for a decent 1500 block since all the other parts are basically in good shape I am not sure if the cam can be saved, although I should think that the bearing journals could be ground down to early cam dimensions, and the block fitted with bearings, which is probably a better deal in the long run. The cam itself, other than the bearing journal, is in great shape and it may even be possible to save the journal itself by regrinding just that journal. Anyway it looks like the quest continues and the wife will have to wait a bit longer for her higher torque engine
Barry Schwartz San Diego, CA -------------------------------------------------------------------- mail2web - Check your email from the web at http://link.mail2web.com/mail2web _______________________________________________ Support Team.Net http://www.team.net/donate.html Suggested annual donation $11.47 You are subscribed as [email protected] [email protected] http://autox.team.net/mailman/listinfo/spitfires http://www.team.net/archive
