Mine did this a few months ago :( For me..... No other signs other than... a)Clutch wouldn't/didn't release (couldn't understand why it wouldn't go in gear anymore) ... there was to much movement forward from the main crank in the block when the clutch thrust bearing tries to push the clutch cover plate to release the clutch plate. b)Metal filings in the engine oil and with a magnetic sump plug the one of the thrust bearings came out on the end of the magnet when I took the plug out! To check 1) Check end play on crank drive pulley ie doesn't have excessive play and is in tolerance. 2) Drop the sump and take off rear end cap, check thrust washers are in place - recheck tolerances and replace with new ones to compensate for mileage. To Repair 1) Replace thrust washers with new ones correct new ones in tolerances (to compensate for mileage). Parts $10 2) Obtain replacement engine New or Refurbished $600 - $5000 + 3) Repairable block/crank - Brake down engine and re machine replace necessary parts $1000 + 4) Repair engine with replacement machined block and crank plus parts as necessary $2000 + Notes: Make sure the thrust washers are in the right way round! The grinding of gray cast iron block on a //Tuftrided high carbon steel crank - is a very quiet sound... but an expensive one!
On 8/27/2010 11:37 AM, Jim Muller wrote: > What if a thrust washer falls out (or wears away) would be the > result? Would it create strange engine noises? I'm musing over > possibilities... > -- Regards Cleobury P _______________________________________________ [email protected] Donate: http://www.team.net/donate.html Suggested annual donation $11.47 Archive: http://www.team.net/archive Forums: http://www.team.net/forums Unsubscribe/Manage: http://autox.team.net/mailman/options/spitfires/[email protected]
