Dear all,

This is to inform you that a new version of the draft 
draft-ruan-spring-priority-flow-control-sid has been uploaded to the IETF 
datatracker, with the link as follows:
https://datatracker.ietf.org/doc/draft-ruan-spring-priority-flow-control-sid/

 This draft leverages SRv6 policy’s explicit path orchestration  capabilities 
to extend PFC-based flow control to cross-DC WANs, enabling tenant-isolated, 
scalable flow control for RDMA/RoCEv2 traffic.

The core content includes

      1. Defining a new SRv6 Endpoint behavior End.X.PFC, an enhanced variant 
of the standard End.X behavior, used to identify PFC-capable interfaces in WAN 
and support the precise path-based delivery of PFC backpressure frames;

      2. Proposing two deployment modes for PFC backpressure signal 
transmission based on SRv6: controller-pre-deployed SRv6 tunnels and 
device-auto-triggered dynamic tunnel creation, to adapt to different WAN 
network deployment scenarios;

Key Revisions in This Version:

     In response to the discussions on the previous mail list, we have 
optimized and revised the draft content, mainly including eliminating ambiguous 
descriptions about the End.X.PFC behavior, and supplementing the detailed 
deployment specifications of SRv6 tunnels for PFC signal transmission, to make 
the technical solution more clear and operable.

Request for Attention and Discussion

     Given that the flow control mechanism defined in this draft is not only 
related to the SPRING working group's SRv6 technology system, but also has 
potential relevance to the research scopes of RTGWG, we sincerely invite all 
colleagues from the two working groups to pay attention to this draft, conduct 
in-depth discussions on the technical solution, and put forward valuable 
questions and revision suggestions.

We look forward to your feedback and will actively respond to and discuss all 
comments to further improve the draft.

Best regards,

RuanZheng




[email protected]
_______________________________________________
spring mailing list -- [email protected]
To unsubscribe send an email to [email protected]

Reply via email to