As I have mentioned before on this forum... We have a severe shortage of local AHJ's here who can "read between the lines". It is either taken literally or ignored.
In this case there are 3/4 inch slip x thread adaptors installed for head adaptors and a bushing could not protrude above the brass insert. We are cutting the branchline fittings out (there is not room to cut off the existing fittings and add a coupling) and installing new drops with 3/4 x 1/2 adaptors to meet the letter of the law, but I think it is a waste of time and resources. Greg Living Water Fire Protection, LLC 1160 McKenzie Road Cantonment, FL 32533 850-937-1850 Fax: 850-937-1852 -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of [EMAIL PROTECTED] Sent: Monday, September 17, 2007 10:28 AM To: [email protected] Subject: Re: BUSHINGS >From the NFPA 13 Handbook - The intent of 6.4.6.1 prohibits the use of bushings where a one-piece reducing fitting is commercially available at the time the system is installed. For other than the circumstance cited in 8.14.19.2, in which bushings are temporarily installed to facilitate an unrestricted flow to sprinklers installed below a future drop ceiling, bushings can be used only where reducing fittings are unavailable. Bushings have poorer flow characteristics than reducing fittings and have a greater tendency to leak. The use of bushings under all but the most pressing conditions is discouraged. For example, a particular fitting may actually be manufactured but may be backordered for several months. If the proper reducing fitting cannot be obtained after an exhaustive effort, then the use of bushings can be considered. The final word should be from the AHJ. A good contractor will coordinate with the local AHJ and get his concurrence on the use of bushings before he installs them. Thank You Rahe Loftin, P.E. Region 7 - GSA Office - 817-978-7299 Fax - 817-978-8644 Cell - 817-371-3102 "Greg McGahan" <[EMAIL PROTECTED] To p.com> [email protected] Sent by: cc sprinklerforum-bo [EMAIL PROTECTED] Subject er.org BUSHINGS 09/17/2007 10:10 AM Please respond to [EMAIL PROTECTED] resprinkler.org If you know.... Please tell me the intent of the 6.4.6 limiting the use of bushings to reduce pipe sizes. If there are existing ¾" reducers and ½" sprinklers are needed, what detrimental effect would there be in using a ¾" x ½" bushing? I fail to see the potential negative impact. Thanks, Greg Living Water Fire Protection, LLC 1160 McKenzie Road Cantonment, FL 32533 850-937-1850 Fax: 850-937-1852 _______________________________________________ Sprinklerforum mailing list [email protected] http://lists.firesprinkler.org/mailman/listinfo/sprinklerforum To Unsubscribe, send an email to:[EMAIL PROTECTED] (Put the word unsubscribe in the subject field) _______________________________________________ Sprinklerforum mailing list [email protected] http://lists.firesprinkler.org/mailman/listinfo/sprinklerforum To Unsubscribe, send an email to:[EMAIL PROTECTED] (Put the word unsubscribe in the subject field) _______________________________________________ Sprinklerforum mailing list [email protected] http://lists.firesprinkler.org/mailman/listinfo/sprinklerforum To Unsubscribe, send an email to:[EMAIL PROTECTED] (Put the word unsubscribe in the subject field)
