Thanks,
I does appear i was using the wrong decision tree in the 2007ed of 13

Sent from my iPhone

On Aug 2, 2009, at 6:05 AM, <[email protected]> wrote:

> George,
>  We use the 2002 edition of #13 in my area ,the definition found in  
> 3.9.18
> for "Solid Unit Load" sounds like it fits with your product  
> discription.However,
> it also looks like this is only applicable for the decision tree for  
> General Storage,
> not Rack storage.Just my opinion.
>
> Lamar Vaughn,SET
> ---- George Medina <[email protected]> wrote:
>> Can somebody point me to the location of definitions defining exposed
>> and solid unit loads. I have a rack storage that consist of square
>> blocks of rubber (rectangular strips of used tires) that are made up
>> for bumpers (the likes that would be seen on loading docks where
>> trucks back up to). I am assuming they are Synthetic.
>>
>> Thanks,
>> George Medina Jr.
>>
>>
>> _______________________________________________
>> Sprinklerforum mailing list
>> http://lists.firesprinkler.org/mailman/listinfo/sprinklerforum
>> For Technical Assistance, send an email to: [email protected]
>>
>> To Unsubscribe, send an email to:Sprinklerforum- 
>> [email protected]
>> (Put the word unsubscribe in the subject field)
> _______________________________________________
> Sprinklerforum mailing list
> http://lists.firesprinkler.org/mailman/listinfo/sprinklerforum
> For Technical Assistance, send an email to: [email protected]
>
> To Unsubscribe, send an email to:Sprinklerforum- 
> [email protected]
> (Put the word unsubscribe in the subject field)
_______________________________________________
Sprinklerforum mailing list
http://lists.firesprinkler.org/mailman/listinfo/sprinklerforum
For Technical Assistance, send an email to: [email protected]

To Unsubscribe, send an email to:[email protected]
(Put the word unsubscribe in the subject field)

Reply via email to