Does anyone have a spare 1" male threaded part for the VSR-ST union? I have access to the rest of the switch, but the part needed to screw into my pipe is missing.

On 10/12/2016 10:57 AM, rongreenman . wrote:
You'd need a hydro pump to overpressure your system but although your switch is doing what it should as mentioned, that switch does not have a built in time delay according to earlier reply. Changing it to one with a time delay would solve the problem. But why not just disconnect it. The is no requirement in 13d for an audible alarm or monitoring.

On Wednesday, October 12, 2016, Barry Levine < <>> wrote:

    I assume attaching a water hose to my test valve wouldn't help, as
    the pressure from inside and outside would be the same. How do you
    suggest I add pressure to my system?

    On 10/12/2016 9:52 AM, Steele, Andrew wrote:

    I've heard of contractors pumping up sprinkler systems a few lbs
    over domestic supply, rather than leaving the sprinkler at supply
    pressure,  so there is no subsequent flow alarm after running an
    Inspectors test.

    For example, our City water pressure trends up in the very late
    hours, then down as daytime usage increases.  This is about a
    five to eight pound change, sometimes it's enough to cause
    systems with failed check valves and short flow detection cycles,
    to alarm.

    On Oct 12, 2016 8:38 AM, "Steele, Andrew"
    <javascript:_e(%7B%7D,'cvml','');> wrote:

        Check valve failure, so that the sprinkler leg is no longer

        -----Original Message-----
        From: Sprinklerforum
        On Behalf Of Barry Levine
        Sent: Wednesday, October 12, 2016 1:01 AM
        Subject: Seeking false water flow alarm suggestions

        I drained all the water from my pipes when I installed a new
        water filter/softener system in my home. After installing the
        new system, which replaced some 3/4" pipe with 1" pipe in my
        home water system, I have been getting false alarms from my
        Potter Electric Signal Co VS-SP flow sensor. I flushed my
        sprinkler system using the drain and the test valve, yet I
        believe some air pockets may still remain in my two areas of
        coffered ceilings, where the sprinklers sit 1 foot above the
        rest of the system. Potter recommends replacing the VS-SP
        with a VSR-ST. I'd prefer not spending the money to replace
        the sensor, but I'd like to hear from the professionals
        before I make that decision. I'm thinking there may be other
        solutions, especially since I never had any false alarms
        during the previous 20+ years. Possibly I could attach saddle
        valves between each of the two sprinklers in the two coffered
        ceilings and bleed the air out. Unfortunately, I've never had
        any long-term luck with saddle valves, as they have all
        become inoperative over time. I've attached a photo of my
        water system in case that might be helpful. Feel free to ask
        any questions or offer any solutions. Thank you.

    _Web <>_   | _Twitter
    <>_ | _Facebook
    | _YouTube <>_ | _Nixle
    <>_ | E-mail Newsletters


    Sprinklerforum mailing list

-- Sent from Gmail Mobile

Sprinklerforum mailing list
Sprinklerforum mailing list

Reply via email to