On 12/16/2014 01:35 PM, Joseph Martinot-Lagarde wrote:
Le 16/12/2014 01:01, Adrian Klaver a écrit :
On 12/15/2014 03:51 PM, Srinivasan Rajaraman wrote:
Thank you Adrian. I am switching from MATLAB to Python, so I like
Spyder more than IPython console.
I am not following. If you use Spyder I presume you will be running code
in it. If you do that, you will be running the code in a console. If
IPython is installed on your system(which I believe it is via Anaconda)
then it will be one of the consoles available. I think you will find
running the code in IPython will be a better experience.
It depends on how you run code. IPython is great if you always run code
in the same interpreter, or run interactive commands.
Personally I prefer writing scripts (event for a few lines) and running
them from a fresh interpreter. I've been bitten too much by old
variables (especially in matlab), so I prefer to know exactly what has
been run. In this case IPython gives no benefit while python is way
I figured that is what Run again last file(Ctrl+F6) is for:) At any rate
the OP was asking about interactive commands, so I went on the
assumption that was what they wanted to use.
faster to start up.
Joseph
--
Adrian Klaver
[email protected]
--
You received this message because you are subscribed to the Google Groups
"spyder" group.
To unsubscribe from this group and stop receiving emails from it, send an email
to [email protected].
To post to this group, send email to [email protected].
Visit this group at http://groups.google.com/group/spyderlib.
For more options, visit https://groups.google.com/d/optout.
