mherger wrote:
>
> First check permissions.
First, I did make a full backup of the folders.
Then I stopped my original LMS docker instance and installed your image
pointing to the same original folder locations for /config
So, since my old LMS had all the permissions it needed, shouldn't I
assume that these would be sufficient for the new LMS as well?
I didn't change or modify anything.
mherger wrote:
>
> Can you confirm your state folder would have three sub-folders cache,
> logs, and prefs?
My state folder has the following sub folders:
Code:
--------------------
cache
etc
logs
prefs
--------------------
Then I simply restarted my old LMS instance, and it runs just fine. So
obviously, my attempt to run your LMS image haven't made any changes to
any config files.
At least not causing any notisable problems for my old instance. So I
didn't have to restore the backup.
mherger wrote:
>
> Make sure you have a backup of those folders first. Then try to wipe the
>
> ..db files, just to see whether the prefs were sane. And/or remove the
> dbsource entry from the server.prefs file.
I will try that too (but I don't see why that would help as long as it
cannot find these files)
QNAP TS-453Be 4x3TB RAID5 QTS 4.5.1
LMS 8.0.0 running in Docker
Home Assistant v0.118 running in Docker
Pi-Hole running in Docker
QNAP TS-251 2x3TB RAID0, QTS 4.5.1
Madsonic 6.2 running in Docker
Node Red running in Docker
QNAP TS-Mini 2x1TB Raid 10, QTS 4.5.1
R&D and Test server
------------------------------------------------------------------------
oyvindo's Profile: http://forums.slimdevices.com/member.php?userid=19302
View this thread: http://forums.slimdevices.com/showthread.php?t=113294
_______________________________________________
Squeezecenter mailing list
[email protected]
http://lists.slimdevices.com/mailman/listinfo/squeezecenter
