Hello there!
I'm new to squid-cache and am having some problems using authentication.
Before I go further I figure it would be helpful for you to know my
configuration
OS : Fedora Core
Squid Version : squid-2.6.STABLE3
Authentication Module : mysql_auth-0.8.
configured with : ./configure --enable-ssl
Install location : /usr/local/squid/
MySQL Auth : /usr/local/squid/libexec
Added the following to Squid.conf
auth_param basic realm Private Access
auth_param basic program /usr/local/squid/libexec/mysql_auth
auth_param basic credentialsttl 5
auth_param basic children 5
acl sip src ***.***.***.***
acl MyPeople proxy_auth REQUIRED
http_access allow sip MyPeople
When I run this with the obvious IP address replaced with real numbers I get
2006/09/04 21:48:12| WARNING: No units on 'auth_param basic
credentialsttl 5', assuming 5.000000 second
Aborted (core dumped)
However, if I comment out like this and run it the program starts fine
without a problem
#auth_param basic realm Private Access
#auth_param basic program /usr/local/squid/libexec/mysql_auth
#auth_param basic credentialsttl 5
#auth_param basic children 5
acl sip src ***.***.***.***
#acl MyPeople proxy_auth REQUIRED
http_access allow MyPeople
The file core.10180 was created in /usr/local/squid/var/cache/
When I use GDB : GDB -c core.10180
I get the following response:
Core was generated by `./squid -N -f /usr/local/squid/etc/squidAuth.conf'.
Program terminated with signal 6, Aborted.
#0 0x006877a2 in ?? ()
I have also tried making my own simple reader in PERL to simply return
"OK" as a hard-coded value on STDOUT
auth_param basic program /usr/bin/perl /usr/local/squid/libexec/perlAuth.cgi
Which does not work either and generates the same type of error.
Any suggestions from the listserv?
Thanks in advance
Kevin Gordon
