I just tried --with-maxformargsize=n
instead of --with-maxmsgsize=n
Instead of a new page indicating that I have exceeded the max
allowable, (What I got with maxmsgsize set)
I get a red message within the attachment frame:
"ERROR: Maximum message size is 2048 KB"
Lets see what happens when I try BOTH :-)
Adam
At 12:42 PM 12/11/00 -0700, [EMAIL PROTECTED] wrote:
>Hi Adam;
>
>I think the option you're looking for is:
>
> * --with-maxformargsize=n - like the above, but applies to an HTTP
> multipart/formdata post. This is approximately the largest
> attachment that can be uploaded SqWebMail.
>
>Hope this helps,
>
>Tren.
>
>=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-
>- Tren Blackburn - Owner mailto:[EMAIL PROTECTED] =
>= End of Time Networks http://www.theendoftime.net -
>- (403) 269-2122 =
>=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-
>
>On Mon, 11 Dec 2000, Adam Manock wrote:
>
> > "sqwebmail-1.0.3/Install" states:
> >
> > * --with-maxmsgsize=n - maximum size of messages (including
> > attachments. Defaults to 2097152 (two megabytes). Note that
> > attachments are base64-encoded, which adds 25% overhead, so the
> > maximum size of attachments is really about 1.5 megabytes
> >
> > I added --with-maxmsgsize=14000000 to the list of configure options in
> > sqwebmail.spec and built (in SPECS) with rpm -bb and I am still limited
> > to 2Mb on attachment uploads. I also added --enable-https and that
> > worked, so I'm sure the right spec file was being used for the build.
> >
> > I did notice that maxmsgsize doesn't appear in configure anymore...
> >
> > Does the option still work / exist??
> >
> > Adam
> >
> >
