The STUN solutions for NAT traversal is classified as near-end.This solutions implemented on the client-side, Then you don't need to configure kamailio. Be notice only the TURN solution is used on server-side. The TURN solution needs some configurations in Kamailio. With Regards.Mojtaba
On Mon, May 7, 2018 at 5:29 PM, Wilkins, Steve <[email protected]> wrote: > So If I already have a Stun Server, I don’t need to configure Kamailio to > use that Server…Is that correct? > > > > Thank you > > > > From: sr-users [mailto:[email protected]] On Behalf Of > Sergiu Pojoga > Sent: Sunday, May 6, 2018 11:49 AM > To: Kamailio (SER) - Users Mailing List <[email protected]> > Subject: Re: [SR-Users] STUN > > > > Simple, load the stun module then point the device' stun address to your > kamailio host on port 5060 (or whatever SIP listening port is configured) > > > > On Sun, May 6, 2018 at 11:12 AM, Wilkins, Steve <[email protected]> wrote: > > Hello all, > > > > Does anyone know the current status of how to enable STUN. I am using > Kamailio Ver 5.x. > > > > Thank you, > > -Steve > > > _______________________________________________ > Kamailio (SER) - Users Mailing List > [email protected] > https://lists.kamailio.org/cgi-bin/mailman/listinfo/sr-users > > > > > _______________________________________________ > Kamailio (SER) - Users Mailing List > [email protected] > https://lists.kamailio.org/cgi-bin/mailman/listinfo/sr-users > -- --Mojtaba Esfandiari.S _______________________________________________ Kamailio (SER) - Users Mailing List [email protected] https://lists.kamailio.org/cgi-bin/mailman/listinfo/sr-users
