Hi,
This is how I have the TTSSH configured and it works fine when I set up the
X-Server to connect to the Unix Server using the check box "XDMCP by
Broadcast, but I would like to do this using the "XDMCP by Query Host"
option.
Also the XDMCP UDP =177 is the default value that was set up for me.
The reason I would like to use the XDMCP by Query Host option instead is
because broadcasts will not get across a router.
Did you need to specify the port # 6000 in TTSSH when performing SSH
Forwarding, as I have described below ?
How did you actually specify Exceed to start in "Passive mode" ?
Hi,
it's not so difficult. I'm using TTSSH 1.5.1 together with Exceed 6.1 aud
it works fine.
1st: Mark the checkbox in TTSSH "Setup" -> "SSH Forwarding" which is
labeled "X Forwarding, Display Remote X applications on local server"
2nd: Start Exceed in "passive mode"
3rd: Connect with TTSSH to your UNIX box.
4th: Start your Xsession (eg. on Sun Solaris running CDE:
/usr/dt/bin/Xsession)
It works fine if X11 Forwarding is enabled in your sshd on the UNIX box
/Stefan
-----Ursprungliche Nachricht-----
Von: asosin [mailto:[EMAIL PROTECTED]]
Gesendet am: Freitag, 31. Marz 2000 16:45
An: '[EMAIL PROTECTED]'
Betreff: Re: SSH X11 Forwarding ?
Hello,
I'm new to the SSH1 protocol and perhaps someone that had a little bit of
experiance with it could give me some pointers ?
I would like to perform X11 forwarding to one of our Unix Servers , but
it's not working for me.
Here are the steps I took to try the X11 forwarding to work on TTSSH 2.3
using SSH protocol V1.5 :
a). Configure the TTSSH with Forwarding as follows:
Setup > SSH Forwarding > Add
Then Forward Local port 6000 to remote machine #.#.#.# on port 6000.
Then Save those configurations.
b).XDMCP by Query Host, XDMCP by Indirect Host and XDMCP by Broadcast are
the options that you can set in
X-Deep/32 X-Server.
I chose to use XDMCP by Query Host with the XDMCP Hostname = 127.0.0.1
(Thus all the X-Server communication would now be forwarded through the SSH
software on port 6000 /X-Server port to the
IP number is pecified #.#.#.#
c). Now ran any X11 programs all you have to do is execute them at the SSH
command prompt.
In theory this was supose to work, but I don't know what I am doing wrong
perhpas someone who got it to work properly can point out what I should
have done ?
The X-Deep software is good at the at price, compared to Exceed which costs
490. Does anyone know of any X-Server software for Windows that is
affordable and works great ? I included a couple of the ones I found on
the net, but I hope
someone can recommend one that they feel is a great deal.
Is there a difference in the security of using Exceed Vs. X-Deep if you
will be running it over SSH ?
MI/X 2.0 X-Server - 25
http://www.microimages.com/www/html/mix/
Exceed X-Server - 490
http://www.unipress.com/hbird/exceed/
How to setup X forwarding?
X-Deep X-Server - 49
http://www.pexus.com/Product_Information/product_information.html
HOBLink X-Server 175
http://www.hob.de/www_us/produkte/connect/jwt.htm
