I was at the Home Depot last night to get a dimmer switch and stumbled 
across something useful in the electrical aisle: 12-4 AWG Polyolefin Heat 
Shrink Tubing (3"). 

I bought some (three pieces for under $2) and put a piece over the 
pressure spring that goes between the tender gas tank and the backhead 
of my Accucraft C-16. That silver spring has always bugged me, and the 
black tubing was just the trick. It is enough larger that it slides over easily 
and doesn't have to be shrunk on. This leaves it flexible, though I imagine 
putting the jet into the backhead and shrinking it in place would give you 
the desired curve.

Anyhow, if you have a C-16 and don't like that sliver spring hanging out 
the back of your cab, there's a cheap and effective solution.

-vance-

"I wish to God these calculations had been executed by steam" -- 
Charles  Babbage


_______________________________________________
SSLiveSteam mailing list
Send messages: [email protected]
Cancel subscription: http://postfix.45mm.com/mailman/listinfo/sslivesteam
Rules: http://www.45mm.com/sslivesteam_guide.html

Reply via email to