Whenever there is a channel width change from 40 Mhz to 20 Mhz, the hardware is reconfigured to ht20. Meantime before doing the rate control updation, the packets are being transmitted are selected rate with IEEE80211_TX_RC_40_MHZ_WIDTH.
While transmitting ht40 rate packets in ht20 mode is causing baseband panic with AR9003 based chips. ==== BB update: BB status=0x02001109 ==== ath: ** BB state: wd=1 det=1 rdar=0 rOFDM=1 rCCK=1 tOFDM=0 tCCK=0 agc=2 src=0 ** ath: ** BB WD cntl: cntl1=0xffff0085 cntl2=0x00000004 ** ath: ** BB mode: BB_gen_controls=0x000033c0 ** ath: ** BB busy times: rx_clear=99%, rx_frame=0%, tx_frame=0% ** ath: ==== BB update: done ==== Cc: [email protected] Signed-off-by: Rajkumar Manoharan <[email protected]> --- drivers/net/wireless/ath/ath9k/rc.c | 3 ++- 1 files changed, 2 insertions(+), 1 deletions(-) diff --git a/drivers/net/wireless/ath/ath9k/rc.c b/drivers/net/wireless/ath/ath9k/rc.c index 1754221..ba7f36a 100644 --- a/drivers/net/wireless/ath/ath9k/rc.c +++ b/drivers/net/wireless/ath/ath9k/rc.c @@ -689,7 +689,8 @@ static void ath_rc_rate_set_series(const struct ath_rate_table *rate_table, if (WLAN_RC_PHY_HT(rate_table->info[rix].phy)) { rate->flags |= IEEE80211_TX_RC_MCS; - if (WLAN_RC_PHY_40(rate_table->info[rix].phy)) + if (WLAN_RC_PHY_40(rate_table->info[rix].phy) && + conf_is_ht40(&txrc->hw->conf)) rate->flags |= IEEE80211_TX_RC_40_MHZ_WIDTH; if (WLAN_RC_PHY_SGI(rate_table->info[rix].phy)) rate->flags |= IEEE80211_TX_RC_SHORT_GI; -- 1.7.5.1 _______________________________________________ stable mailing list [email protected] http://linux.kernel.org/mailman/listinfo/stable
