At 08:00 PM 6/9/99 -0500, Kevin wrote:

>technology.  Patrik have you ever cut a 2' by 4' by 4' block of limestone by
>hand saw?  Well it takes a good sharp blade and goes about 1 inch an hour
>and takes a lot of rhythm and is a good work out.

Are you willing to try a carbide tipped hand saw? You'd need to test it to
see if the tool marks it leaves are the same, but I'd suspect that,
considering the original 19th century work is heavily weathered the
difference would be minimal. It works best on soft stone like Texas
limestone or Bath stone (which, by the way, are very similar), but you can
use it on Indiana limestone or Portland stone (again, those two are quite
similar). Depending on the stone, you may change that 1" per hour into 1"
per two to six minutes.

I have one made by Sandvik (Denmark I believe??) that is 29" long (75cm)
and have ordered one from Texas that is 18" (45cm). If you remind me, after
I test the Texas stone I can let you know whether it is any good.

I fully understand hand tooling and dressing the stone to create authentic
surfaces; I do a lot of hand tooling to put texture and shadow into my
work; however, for roughing out IMHO there is no reason not to use faster
techniques. Do you buy stone from a mill that uses 11' diamond saws to cut
the blocks, and who in turn gets their blocks from a quarry that uses 12'
diamond tipped chain saws and the like to quarry the blocks, or do you dig
it out of the ground with sledge hammers and pry bars? Where do you draw
the line?

But then, I was always somewhat confused by the Amish. To those not in the
U.S. or not familiar, they are a Christian religion that adheres strictly
to the "old ways"... that means they use only technology that existed as of
a certain date in the mid 19th century. I understand how it makes their
life more peaceful and closer to nature, cuts out the haste and confusion
of modern times. What I find confusing is the concept that using a machine
invented in 1845 brings you closer to godliness than using a machine
invented in 1875.

As I mentioned, I always keep a mallet close at hand and pick it up many
times in a day- (or, for marble, an iron hammer). I feel that the more
different techniques you have available the more versatile you can be,
adjusting the technique to the particular cut you are making.

____________________________________
Walter S. Arnold  * [EMAIL PROTECTED] 
Gallery:        http://www.stonecarver.com
NT Fax: http://www.ntfax-faq.com
Gargoyle postcards: http://www.stonecarver.com/postcard.html



....................................................................
Learning Stone is hosted free by Spunge.org (http://www.spunge.org).
For list info + help, including subscribe/unsubscribe options,
email message "intro stone" to [EMAIL PROTECTED]


Reply via email to