Be careful with the fan solution.  It gets the dust out of your face, the
heavier stuff falls to the floor, and the light, dangerous stuff just keeps
flying around the room.  A 'small' fan will stir the room less.  Ideally you
need to blow (waft) fresh, clean air, and exhaust the dusty stuff.  That'll
get your attention in the winter!

A good furnace filter attached to a box fan will clean the air a bit.

The woodworking community uses dust colletion systems to deal with this
problem.  For short term use, a shop vac is a painfully loud possibility.
The upscale solution uses a quiet motor connected to a squirrel cage fan
that sucks your rubbish through a cyclone separator, and then blows your
dust into a bag filter.  

A cyclone traps all of the wood chips and most of the sawdust.  I have no
idea how it would behave with rock dust.  Bags are rated at micron hole
sizes.  How big is a rock dust mote?!

$300(US) can set you up with a commercial solution.  Or, surplus squirrel
cages and ducts are cheap.  Furnace fans can move a lot of air and have to
be either slowed down or vented to relieve vacuum pressure.  They also don't
have the ideal vane size for this, but they'll do.  Ducting is a
do-it-yourself proposition.  

Curt

-----Original Message-----
From: [EMAIL PROTECTED]

> Something that I use to eliminate most of the dust is a
> fan blowing behind my shoulder.  




............................................................
To get list info + help, including subscribe/unsubscribe
options, email message "intro stone" to [EMAIL PROTECTED]
or visit http://www.learningstone.net/lsemlist.htm


Reply via email to