The bootup message is likely correct.
Are these Seagate drives, and did you remove the jumper from them to permit
them to use the 3.0G signaling rate? (its the little grey jumper on the
back by the data connector... you might need a pin or needle to get it out)
Andrew Hettinger
http://Prominic.NET || [EMAIL PROTECTED]
Tel: 866.339.3169 (toll free) -or- +1.217.356.2888 x.110 (int'l)
Fax: 866.372.3356 (toll free) -or- +1.217.356.3356 (int'l)
Mobile direct: 1.217.621.2540
CompTIA A+, CompTIA Network+, MCP
[EMAIL PROTECTED] wrote on 03/29/2008 06:13:05 PM:
> Can anyone recommend the best way to confirm that my drives are
> properly negotiating to sata2? I have an AOC-SAT2-MV8/marvell88sx
> card, which during boot up prints this, making me question the speed
> of the drives:
>
> SATA Gen1 signaling speed (1.5Gbps)
>
> This is on Nexenta 1.0RC2, which is b85.
>
> Thanks!
> Thomas
> _______________________________________________
> storage-discuss mailing list
> [email protected]
> http://mail.opensolaris.org/mailman/listinfo/storage-discuss
_______________________________________________
storage-discuss mailing list
[email protected]
http://mail.opensolaris.org/mailman/listinfo/storage-discuss
