This code is to debug the rest of the existing CF's, so we can look at the rest of the values.
Signed-off-by: Anton Lundin <[email protected]> --- configuredivecomputerthreads.cpp | 17 +++++++++++++++++ 1 file changed, 17 insertions(+) diff --git a/configuredivecomputerthreads.cpp b/configuredivecomputerthreads.cpp index dc03597..0be3a72 100644 --- a/configuredivecomputerthreads.cpp +++ b/configuredivecomputerthreads.cpp @@ -492,7 +492,9 @@ void ReadSettingsThread::run() case DC_FAMILY_HW_OSTC: { supported = true; unsigned char data[256] = {}; +#ifdef DEBUG_OSTC_CF unsigned char max_CF = 0; +#endif rc = hw_ostc_device_eeprom_read(m_data->device, 0, data, sizeof(data)); if (rc == DC_STATUS_SUCCESS) { m_deviceDetails->setSerialNo(QString::number(data[1] << 8 ^ data[0])); @@ -641,7 +643,9 @@ void ReadSettingsThread::run() m_deviceDetails->setDateFormat(data[91]); // Byte93: // Total number of CF used in installed firmware +#ifdef DEBUG_OSTC_CF max_CF = data[92]; +#endif // Byte94: // Last selected view for customview area in surface mode // Byte95: @@ -726,6 +730,11 @@ void ReadSettingsThread::run() m_deviceDetails->setSamplingRate(read_ostc_cf(data, 20)); // CF29: Depth of last decompression stop m_deviceDetails->setLastDeco(read_ostc_cf(data, 29)); + +#ifdef DEBUG_OSTC_CF + for(int cf = 0; cf <= 31 && cf <= max_CF; cf++) + printf("CF %d: %d\n", cf, read_ostc_cf(data, cf)); +#endif #ifdef DEBUG_OSTC local_hw_ostc_device_eeprom_write(m_data->device, 0, data, sizeof(data)); #endif @@ -753,6 +762,10 @@ void ReadSettingsThread::run() m_deviceDetails->setGfHigh(read_ostc_cf(data, 33)); // CF58: Future time to surface setFutureTTS m_deviceDetails->setFutureTTS(read_ostc_cf(data, 58)); +#ifdef DEBUG_OSTC_CF + for(int cf = 32; cf <= 63 && cf <= max_CF; cf++) + printf("CF %d: %d\n", cf, read_ostc_cf(data, cf)); +#endif #ifdef DEBUG_OSTC local_hw_ostc_device_eeprom_write(m_data->device, 1, data, sizeof(data)); #endif @@ -775,6 +788,10 @@ void ReadSettingsThread::run() m_deviceDetails->setAGFHigh(read_ostc_cf(data, 68)); // CF69: Allow Gradient Factor change m_deviceDetails->setAGFSelectable(read_ostc_cf(data, 69)); +#ifdef DEBUG_OSTC_CF + for(int cf = 64; cf <= 95 && cf <= max_CF; cf++) + printf("CF %d: %d\n", cf, read_ostc_cf(data, cf)); +#endif #ifdef DEBUG_OSTC local_hw_ostc_device_eeprom_write(m_data->device, 2, data, sizeof(data)); #endif -- 1.9.1 _______________________________________________ subsurface mailing list [email protected] http://lists.subsurface-divelog.org/cgi-bin/mailman/listinfo/subsurface
