Hi Rick
I opened my dive log in tinca, removed all dive sites and synced my Uemis.
No issues so far.
I'll commit my dive spot changes and get the new master, can you send the patch
so I see what you changed ?
G. Lerch
Dienstag, 8. September 2015 23:03 +0200 von Rick Walsh <[email protected]>:
>
>On 9 Sep 2015 02:55, "Dirk Hohndel" < [email protected] > wrote:
>>
>> On Tue, Sep 08, 2015 at 09:19:26AM -0700, Dirk Hohndel wrote:
>> > As for removing the dive sites from the XML file, doing so doesn't crash
>> > Subsurface but it doesn't remove the references to non-existing divesites,
>> > either. I'll look into this a little more this morning, I think that
>> > behavior isn't correct. If a dive site doesn't exist, we shouldn't store a
>> > reference to it.
>>
>> OK, I just pushed a commit that will make this much easier.
>> Pull the latest master and rebuild.
>> Then open your XML file in your favorite editor :-)
>> Remove the divesites section at the top of the file.
>> Save again.
>>
>> Now open this file in Subsurface. And save it again. I think you may have
>> to make a dummy change for it to actually write it out. And once it's
>> saved all references to divesites are gone.
>>
>Thanks for this. I've also got a few duplicate and bogus dive sites in my log,
>so this should make cleaning them up easier.
>It is very easy to create bogus sites when using the Marble interface if you
>save your mistake, and no obvious way to correct it without editing the xml
>file. An ui method would be good.
>Rick
_______________________________________________
subsurface mailing list
[email protected]
http://lists.subsurface-divelog.org/cgi-bin/mailman/listinfo/subsurface
