Miika, anyone,
For some odd reason we get random test failures in TestParse. This has been
going on for
quite a while, but I figure I at least point it our in case someone wants to
take a look.
Here's what we see when it fails:
4/11 Test #4: TestParse ........................***Failed 3.97 sec
<>********* Start testing of TestParse *********
<>Config: Using QtTest library 5.9.0, Qt 5.9.0 (x86_64-little_endian-lp64
shared (dynamic) release build; by GCC 5.3.1 20160406 (Red Hat 5.3.1-6))
<>PASS : TestParse::initTestCase()
<>number of dives 4
<>number of dives 5
<>number of dives 6
<>number of dives 7
<>FAIL! : TestParse::testParse() Compared values are not the same
<> Actual (written.takeFirst().trimmed()): "<sample time='0:00 min'
depth='2.68 m' temp='11.0 C' ndl='240:00 min' po2='0.9 bar' />"
<> Expected (readin.takeFirst().trimmed()) : "<sample time='0:00 min'
depth='2.68 m' temp='11.0 C' ndl='240:00 min' />"
<> Loc:
[/home/travis/build/Subsurface-divelog/subsurface/tests/testparse.cpp(153)]
It seems like we sometimes write the po2 value and sometimes we don't. Because
usually when
I re-run the test, it passes again.
I'd appreciate if someone could take a look.
/D
_______________________________________________
subsurface mailing list
[email protected]
http://lists.subsurface-divelog.org/cgi-bin/mailman/listinfo/subsurface
