> On 20 Oct 2017, at 6.38, Willem Ferguson <[email protected]> > wrote: > > > >> On 20/10/2017 12:22, Dirk Hohndel wrote: >> >> it will show you a curses interface with the cmake variables for this >> project. >> Half way down there should be NO_DOCS - what is it set to? >> How about NO_USERMANUAL ? >> >> If either is ON, move the curser down, press enter to toggle, then 'c' to >> configure and 'g' to generate. >> If both are set to OFF, then just press 'q' to quit >> >> /D > > NO_DOCS OFF > NO_MARBLE OFF > NO_PRINTING ON > NO_USERMANUAL ON > > I use ccmake to change NO_USERMANUAL to OFF. (Had to do this as su > because of write privileges.) > > Ececuted sudo ccmake again to make sure NO_USERMANUAL is OFF. It was. > > Rebuilt Subsurface (build 1031). Problem not solved but I think it may > be finger trouble. This probably close to the reason for the problem.
I think you will need to run "cmake .." to get the new config into use. miika _______________________________________________ subsurface mailing list [email protected] http://lists.subsurface-divelog.org/cgi-bin/mailman/listinfo/subsurface
