Hello,
Thank you for your help. My G2 is now perfectly recognized by Subsurface.
I would not find without your help.
Would it be possible to integrate this udev rule during the subsurface
installation?
Thanks again,
Stéphane
Le 29/08/2019 à 18:23, Adric Norris a écrit :
You likely need to create a udev rule, to set appropriate permissions
after the device is connected via USB. Here's the udev rule file I use
for this purpose.
$ cat /etc/udev/rules.d/51-divecomputers.rules
# ScubaPro G2
SUBSYSTEM=="usb", ATTR{idVendor}=="2e6c", ATTR{idProduct}=="3201",
OWNER:="adric", GROUP:="adric", MODE:="0600"
Please note that "adric" is the name of my local user account, so
you'll need to adjust it to match your environment. Also, you'll need
to run "|udevadm control --reload-rules" after dropping the file into
place... followed by "sudo udevadm trigger" if the device is already
plugged in.
|
On Thu, Aug 29, 2019 at 11:14 AM Stéphane <[email protected]
<mailto:[email protected]>> wrote:
Bonjour,
Je souhaite importer mes plongées depuis un Scubapro G2, en mode USB.
Mais il n'est pas reconnu.
Est-il compatible avec le logiciel Subsurface ?
Je suis sur Ubuntu Ubuntu 18.04.3 LTS et noyau 4.15.0-58-generic.
Je n'ai pas trouvé d'info sur le Forum.
En vous remerciant pour votre retour.
Stéphane Poveda
_______________________________________________
subsurface mailing list
[email protected]
<mailto:[email protected]>
http://lists.subsurface-divelog.org/cgi-bin/mailman/listinfo/subsurface
--
"In the beginning the Universe was created. This has made a lot of
people very angry and been widely regarded as a bad move." -Douglas Adams
_______________________________________________
subsurface mailing list
[email protected]
http://lists.subsurface-divelog.org/cgi-bin/mailman/listinfo/subsurface
