Hello All,
I was wondering if I can get all the edge boundary points in the netedit.exe?As
shown in the picture, for both one-way or two-way edge (1->2), can I get the
boundary points A, B, C and D? It is even better if I can get points E and F
for the two-way edge.
I understand that I can get the point A and B in
\src\netbuild\NBNodeShapeComputer::computeNodeShapeDefault() where Position p;
the junction shape points are calculated (when the subject edge is *i (1->2)),
but how about point C, D and E, F?
Any information would be appreciated.
Thank you and cheers.
Zeng
------------------------------------------------------------------------------
What NetFlow Analyzer can do for you? Monitors network bandwidth and traffic
patterns at an interface-level. Reveals which users, apps, and protocols are
consuming the most bandwidth. Provides multi-vendor support for NetFlow,
J-Flow, sFlow and other flows. Make informed decisions using capacity
planning reports. https://ad.doubleclick.net/ddm/clk/305295220;132659582;e
_______________________________________________
sumo-devel mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/sumo-devel
