It looks as if your signal plan uses the state 'g' which forces slow-down. use 'G' instead.
Am Mi., 7. Nov. 2018 um 12:09 Uhr schrieb <[email protected]>: > I tried that. But once the vehicle enters the junction, it seems to ignore > the other vehicles. The problem is that, it slows down before entering the > junction as shown in the image below. > > > > > > Thank you > > Best Regards > > Aashik Chandramohan > > > > *From: *Jakob Erdmann <[email protected]> > *Sent: *07 November 2018 12:04 > *To: *Sumo project User discussions <[email protected]> > *Subject: *Re: [sumo-user] Detecting collisions in junctions > > > You should definitely get them to ignore foe traffic by setting > jmIgnoreFoeProb=1 jmIgnoreFoeSpeed=100 > in the vType definition. > > Am Mi., 7. Nov. 2018 um 11:19 Uhr schrieb <[email protected]>: > >> Hi Jakob, >> >> >> >> Thanks, but the vehicles still slow down while approaching the junction, >> If it notices that there might be a possibility for a collision in the >> junction. Is there a way to remove this behaviour? >> >> >> >> Thank you >> >> Best Regards >> >> Aashik Chandramohan >> >> >> >> *From: *Jakob Erdmann <[email protected]> >> *Sent: *07 November 2018 10:59 >> *To: *Sumo project User discussions <[email protected]> >> *Subject: *Re: [sumo-user] Detecting collisions in junctions >> >> >> Hello, >> To detect collisions, the junction must not be set to "unregulated". >> See >> http://sumo.dlr.de/wiki/Simulation/Safety#Deliberately_causing_collisions >> for hints on causing collisions. >> regards, >> Jakob >> >> Am Mi., 7. Nov. 2018 um 10:52 Uhr schrieb <[email protected]>: >> >>> Hi, >>> >>> >>> >>> Is it possible by any chance to simulate collisions in junctions? >>> >>> By using the junction type as unregulated, the vehicles seem to pass >>> through each other but the collisions are not detected. >>> >>> Also having all the lights on the junction as green doesn’t make a >>> difference as the vehicles automatically slow down to avoid a collision. >>> >>> >>> >>> Hence is there any other way to simulate and detect collisions in the >>> junctions? >>> >>> >>> >>> Thank you >>> >>> Best Regards >>> >>> Aashik Chandramohan >>> >>> >>> _______________________________________________ >>> sumo-user mailing list >>> [email protected] >>> To change your delivery options, retrieve your password, or unsubscribe >>> from this list, visit >>> https://www.eclipse.org/mailman/listinfo/sumo-user >>> >> _______________________________________________ >> sumo-user mailing list >> [email protected] >> To change your delivery options, retrieve your password, or unsubscribe >> from this list, visit >> https://www.eclipse.org/mailman/listinfo/sumo-user >> > _______________________________________________ > sumo-user mailing list > [email protected] > To change your delivery options, retrieve your password, or unsubscribe > from this list, visit > https://www.eclipse.org/mailman/listinfo/sumo-user >
_______________________________________________ sumo-user mailing list [email protected] To change your delivery options, retrieve your password, or unsubscribe from this list, visit https://www.eclipse.org/mailman/listinfo/sumo-user
