in the left bus stop, the busstop lane is not connected to the next edge and requires lane-changing (this is appropriate). In the right bus stop, the busstop lane is connected but the leftmost lane does not allow continuation (this causes undesired lane changes by the vehicles). The change at the left busstop occurse for strategic reasons due to the mismodelled connections at the right bus stop.
When two lanes are available for driving, and no other vehicles are present, the vehicle will tend to drive on the right due to the 'oblication to drive right'. This happens after a time threshold and is independent of bus stops. The behavior can be reduced per vehicle type by setting the 'lcKeepRight' parameter to a value below 1. regards, Jakob Am Do., 27. Juni 2019 um 12:26 Uhr schrieb steniero <[email protected]>: > Hi, > I have a simulation with three lanes, and a bus stop. Not all my vehicles > stop, and for the ones that don't I would like them to keep the fastest > lane. As you can see in my sequence of pictures attached, though, my > vehicles change lane in the presence of a bus stop (so when the lanes pass > from 2 to 3). Is there any way to change the logic and force a vehicle to > stay in the left lane and approach the stop only if needed? > The situation depicted does not happen for every stop in my circuit, only > for some. > > Thank you very much > Stefano > _______________________________________________ > sumo-user mailing list > [email protected] > To change your delivery options, retrieve your password, or unsubscribe > from this list, visit > https://www.eclipse.org/mailman/listinfo/sumo-user >
_______________________________________________ sumo-user mailing list [email protected] To change your delivery options, retrieve your password, or unsubscribe from this list, visit https://www.eclipse.org/mailman/listinfo/sumo-user
