Hi SUMO Users,
I successfully implemented my first rail stop, but JTRROUTER warned that
the beginning and ending edges of the route were not connected to the edge
with the stop on it, even though they are connected, as evidenced by the
fact that the simulation runs properly with trains stopping where they
should (and there's only a single track in each direction). Also, if I
don't specify the "to" edge, the trains disappear after leaving the stop
(accept-all-destinations="true"). Here's the additional file which
JTRROUTER reads:
<additional >
<railStop id="MountainViewNB" lane="MountainView_NB_0" startPos="75"
endPos="225" />
<railStop id="MountainViewSB" lane="MountainView_SB_0" startPos="75"
endPos="225" />
<vType id="rail" length="150" maxSpeed="13" accel="0.8" decel="0.5"
sigma="0.1" speedDev="0.1" color="1,1,0" vClass="rail"/>
<flow id="NB_Caltrain" type="rail" begin="0" end="3600"
from="beg_NB_Caltrain" to="end_NB_Caltrain" number="6" >
<stop railStop="MountainViewNB" duration="90"/>
</flow>
<flow id="SB_Caltrain" type="rail" begin="300" end="3900"
from="beg_SB_Caltrain" to="end_SB_Caltrain" number="6" >
<stop railStop="MountainViewSB" duration="90"/>
</flow>
</additional>
It's just an annoyance since the simulation does run properly, but is there
a reason for this odd behavior?
Thanks,
Albert
_______________________________________________
sumo-user mailing list
[email protected]
To change your delivery options, retrieve your password, or unsubscribe from
this list, visit
https://www.eclipse.org/mailman/listinfo/sumo-user
